COB LED Strip Lights, 3000K Warm White, 16.4ft | 24V 480 LEDs/m, Dot-Free IP67 Waterproof, CRI 90+ Dimmable, Under Cabinet Shelf Cove Lighting

The light surface stays visually consistent across a wide dimming range — that is the result of placing 480 chip-on-board LEDs per meter in a single fused layer rather than spaced individual chips. The continuous light surface can appear softer at close viewing distances, presenting light from a continuous surface rather than distinct points. Where it works well: kitchen cabinet undersides, pantry and closet shelves, stair toe-kicks, bathroom mirror surrounds (seal connections), covered patios and pergolas, retail display cases, and 24V DC RV or marine systems. The flexible 5mm PCB can be routed around most standard installation corners — useful in tight cabinet runs and stair profiles. On color accuracy: at CRI 90+, this strip helps preserve the intended appearance of wall paint, wood grain, and merchandise colors under the 3000K warm output. Useful anywhere the light source is visible and color accuracy is part of the result. IP67 — what it actually means here: the silicone sleeve protects the strip body. To keep that rating at cut ends and wire joints, cap and seal those points with silicone or waterproof end caps before exposure to moisture. Not rated for submersion or unsheltered rain without secondary housing. Quick specs: 16.4ft (5m) per reel | 24V DC | 7W/m (35W per reel) | 480 LEDs/m COB | CRI 90+ | 3000K | 540 lm/m | 5mm PCB | IP67 What is included: one 16.4ft COB strip only. Power supply, dimmer/controller, end caps, and aluminum channel are not included. Do not connect directly to AC mains. Cut only at printed marks. For permanent installs, follow local electrical codes.

• Continuous Light Surface with Wide Dimming Range: COB construction places 480 chips per meter in a single fused layer, creating a continuous light surface with no chip-to-chip spacing. Whether lighting a display shelf at full output or holding a bedroom at a low level, the strip surface itself stays visually consistent
• High Brightness and Color Accuracy: Delivers 540 lumens per meter with CRI 90+ to preserve the intended appearance of wood grain, wall paint, and decor colors under the 3000K warm output. Useful for kitchen task work, display case accent, and vanity lighting where color accuracy matters. Runs at 7W per meter on 24V DC; each 16.4ft reel draws about 35W. PCB width: 5mm
• Versatile Indoor and Outdoor Installation: Install it under kitchen cabinets for shadow-free prep light, at stair toe-kicks so the steps read clearly at night, or inside a retail display case where color accuracy matters. The IP67-rated silicone sleeve handles covered patios, pergolas, and 24V DC RV or marine systems - seal the wire connections and cut ends before any moisture exposure
• Flexible Installation with Important Guidelines: Cut only at the printed marks on the strip. The flexible 5mm PCB can be routed around most standard installation corners. If you are running this in a damp spot - under a sink, on a covered deck - cap and seal the cut ends and wire joints to keep the IP67 rating intact. Compatible with most 24V PWM dimmers. No direct AC connection
• Complete Kit Contents and Additional Requirements: The kit includes one 16.4ft (5m) COB strip. To run it, you will also need a 24V DC power supply, a PWM dimmer or controller, and waterproof end caps for any outdoor or damp spots. All sold separately. For wall or ceiling installs, an aluminum channel with a diffuser gives cleaner heat management and a finished look